TM 5-3895-373-34
2.32
REPLACE/REPAIR PROPULSION MOTOR - Continued
B.
DISASSEMBLE - Continued.
2.
REMOVE VALVE ASSEMBLY FROM HYDRAULIC
ASSEMBLY HOUSING.
NOTE
Set screws (27) will only need to be removed if
replacing hydraulic assembly housing (24).
a.
Remove set screws (27).
b.
Remove plugs (28 and 29) and o-rings (30).
Discard o-rings.
c.
Remove washers (31) and springs (32).
d.
Remove flat washers (33) and hydraulic pistons
(34).
Valve sleeve can only be removed
from
hydraulic assembly housing using valve sleeve
installation tool. Do not force valve sleeve from
hydraulic assembly housing. Damage to valve
sleeve and hydraulic assembly housing can
result from improper removal of valve sleeve.
e.
Use valve sleeve installation tool to unscrew and
remove valve sleeve (35) from port (A) of
hydraulic assembly housing.
GO TO NEXT PAGE
2-446
