TM 5-3895-373-34
2.25
REPAIR STARTER ASSEMBLY - Continued
E.
ASSEMBLE - Continued.
2.
ASSEMBLE
ARMATURE
SUPPORT,
SHIFT
LEVER,
AND
DRIVE
SHAFT
INTO
DRIVE
HOUSING.
a.
Lubricate shift lever (40) and assembled drive
shaft (39) with grease.
b.
Install shift lever (40) onto shift collar on
assembled drive shaft (39).
c.
Install shift lever (40) and assembled drive shaft
(39) into drive housing (29).
d.
Use a drift punch to align hole in shift lever with
holes in drive housing (29).
e.
Use a drift punch to align holes in drive support
with holes in drive housing (29).
NOTE
Drive support must be fully seated in
drive housing.
Drive shaft bearing must be fully
seated in drive support.
f.
With drive shaft bearing seated in drive
support and drive support seated in drive
housing (29), install screw (38), washer (37),
lockwasher (36), and hex nut (35). Tighten hex
nut to 40 lb-in (4, 5 N•m).
g. Install plate (34) and housing plug (33).
h. Install spacers (32) and washers (31 and 30), in
exactly the same order noted at disassembly.
i. Install armature support (28).
j. Install screws (27 and 26). Tighten to 75 lb-in (8,
5 N•m).
GO TO NEXT PAGE
2-348
