TM 5-3895-373-34
D.
ASSEMBLE.
1.
INSTALL BEARINGS, SHROUD, AND IMPELLER
SHAFT ONTO COMPRESSOR HOUSING.
Use care when removing or installing
snap and retaining rings. Snap and
retaining rings are under spring tension
and can act as projectiles when released
and could cause severe eye injury.
a.
Use snap ring pliers and install retaining rings
(22).
b.
Lubricate bearings (21) with clean engine oil.
c.
Install bearings (21).
Use care when removing or installing
snap and retaining rings. Snap and
retaining rings are under spring tension
and can act as projectiles when released
and could cause severe eye injury.
d.
Install retaining rings (20).
e.
Install shroud (18).
f.
Install ring (19).
g.
Gently
guide
impeller
shaft
(9)
through
compressor housing (4).
h.
Firmly push impeller shaft (9) into compressor
housing (4) until ring (19) is seated.
GO TO NEXT PAGE
2-303
