TM 5-3895-373-34
E.
ASSEMBLE Continued.
d.
Hold drive hub (104) with a spanner wrench from
DPA tool kit.
e.
Use an adapter from DPA tool kit to tighten
socket head cap screw (133) to 285 lb-in (32
N•m) while holding drive hub (104) with spanner
wrench from DPA tool kit. Loosen socket head
cap screw and repeat this operation three times
to ensure socket head cap screws are tightened
correctly.
f. Use a thickness gage to check drive hub end
float.
g. Drive hub end float must not exceed 0.010 in.
(0,25 mm) measured between rear face of drive
hub (104) and fuel injection pump.
h. If drive shaft end float is greater than 0.010 in.
(0,25 mm), governor weight cage or fuel injection
pump
housing
must
be
replaced.
GO TO NEXT PAGE
2-269
