TM 5-3895-373-34
E.
ASSEMBLE - Continued.
5.
INSTALL FUEL CONNECTION AND ACCESS
COVER.
a.
Install flat washer (119) and fuel connection
(118).
b.
Install gasket (117) and access cover (116)
and secure with lockwasher (115) and
screw (114).
c.
Install wire rope (113) through screws
(114). Do not permanently attach wire rope
until after fuel injection pump testing is
completed.
6.
INSTALL TRANSFER PUMP ROTOR.
a.
Position outer rotor head assembly (111)
with machined surfaces facing up.
b.
Remove pump impeller (105) and inner
rotor head assembly (125) from outer rotor
assembly (111).
Do not allow plungers to fall out of
inner
rotor
head
assembly.
If
plungers become damaged, the entire
rotor
head
assembly
must
be
replaced. Failure to replace damaged
plungers may cause fuel injection
pump failure or poor performance.
c.
Remove protective caps holding plungers
(126) on inner rotor head assembly (125).
GO TO NEXT PAGE
2-271
