TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
E.
ASSEMBLE Continued.
e.
Assemble thrust sleeve (145) and thrust washer
bearing (144) onto drive shaft (137).
f.
Place drive shaft (137) into governor weight cage
(139) with seal groove on top.
g.
Add a governor weight (143) to governor weight
cage (139). Adjust tool until lip of governor
weight sits on thrust washer bearing (144).
h.
Place remaining governor weights (143) around
drive shaft (137).
i.
Align assembled governor weight cage (139)
with drive shaft (1 37) spline and manually push
drive shaft down to seat governor weights (143)
in governor weight cage.
j.
Use a protective cap from DPA tool kit and install
drive shaft seal (138) onto assembled drive shaft
(137).
3.
INSTALL DRIVE HUB AND GOVERNOR
WEIGHT CAGE INTO FUEL INJECTION PUMP.
a.
Insert governor weight cage (136), weight-end
first, inside fuel injection pump.
b.
Insert drive hub (104) into opposite end of fuel
injection pump, touching governor weight cage
(136).
c.
Install flat washer (135), lockwasher (134), and
socket head cap screw (133).
GO TO NEXT PAGE
2-268
