TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
B.
DISASSEMBLE Continued.
15.
REMOVE SEALING RING.
a.
Remove fuel injection pump housing (146) from
jig.
Do not scratch or gouge inside sealing
surface of fuel injection pump when
removing sealing ring. Leakage and
poor performance may result from
scratches
or
gouges
on
sealing
surfaces. Use caution when prying out
sealing ring from fuel injection pump.
b.
Remove sealing ring (147) using an extractor
from DPA tool kit. Pry out sealing ring from fuel
injection pump housing (146). Discard sealing
ring.
C.
CLEAN.
1.
CLEAN ALL INTERNAL PARTS WITH
LUBRICATING OIL.
2.
DRY ALL INTERNAL PARTS WITH A CLEAN,
LINT-FREE CLOTH.
Cleaning solvent, P-D-680, is TOXIC
and
flammable.
Wear
protective
goggles and gloves. Use only in a well
ventilated area. Avoid contact with skin,
eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame.
Never smoke when using solvent; the
flashpoint for Type m cleaning solvent is
200°F (93,3C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent,
immediately get fresh air and medical help. If solvent
contacts skin or clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and get immediate
medical attention.
3.
RINSE FUEL INJECTION PUMP HOUSING WITH
CLEANING SOLVENT.
4.
DRY FUEL INJECTION PUMP HOUSING WITH A
CLEAN, LINT-FREE CLOTH.
GO TO NEXT PAGE
2-264
