TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
E.
ASSEMBLE - Continued.
4.
INSTALL RETAINING RING, CAM RING, AND
SCREW INTO FUEL INJECTION PUMP.
Use care when installing snap and
retaining rings. Snap and retaining rings
are under spring tension and can act as
projectiles when released and could
cause severe eye injury.
a.
Use snap ring pliers to install retaining ring (132).
b.
Center open points of retaining ring (132) in fuel
injection pump inspection bore.
c.
Install cam ring (131) with arrow facing open end
of fuel injection pump, going in same direction as
arrow printed on housing label.
d.
Turn fuel injection pump over so bottom is facing
up.
e.
Install screw (130). Use a socket from DPA tool
kit to tighten screw (80) to 450 lb-in (51 N•m).
f. Remove tool and use a plastic hammer to tap
screw (130) lightly, to ensure cam ring is not
binding inside fuel injection pump.
GO TO NEXT PAGE
2-270
