TM 5-3895-373-34
2.17
DIESEL ENGINE REPAIR - Continued.
E.
INSTALL - Continued.
u.
Lubricate flat washer (70) with engine oil.
v. Install bearing (69) into timing gear (68).
w. Install timing gear (68) and hub (67).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If thread locking
compound contacts eyes, flush eyes
with water and get immediate medical
attention.
x.
Apply thread locking compound to screw (66).
y.
Install screw (66). Tighten to 55 lb-ft (75 N.m).
z.
Use a thickness gage to check end float of
timing gear (68). End float of timing gear must
be 0.003 to 0.009 in. (0, 08 to 0, 23 mm).
aa.
Use a thickness gage to check gear shaft (79)
end float. Gear shaft end float must be 0.004 to
0.012 in. (0, 10 to 0, 30 mm).
GO TO NEXT PAGE
2-224