TM 5-3895-373-34
C.
INSPECT - Continued.
6.
INSPECT CYLINDER SLEEVES FOR WEAR.
a.
Use a dial indicator to check the internal bore
of Surface P in each cylinder sleeve (143).
Check the internal diameter at the top, middle,
and bottom of the cylinder sleeve.
b.
Cylinder sleeve internal bore diameter must be
3.878 to 3.887 in. (98,50 to 98,72 mm), with
cylinder sleeve installed in engine block.
c.
If cylinder sleeve internal bore exceeds 3.887
in. (98,72 mm), replace cylinder sleeve. Refer
to paragraph D.
7.
INSPECT CAMSHAFT AND CAMSHAFT WASHER
FOR WEAR.
a.
Use an outside micrometer (Item 16, Appendix
D) to measure diameter of Surface Q on
Number I journal on camshaft (122).
b.
Diameter of Number I journal on camshaft
must be 1.9945 to 1.9975 in. (50,660 to 50,736
mm).
c.
If Number I journal is less than 1.9945 in.
(50,660 mm), replace camshaft (122).
d.
Use an outside micrometer (Item 16, Appendix
D) to measure diameter of Surface R of
Number 2 journal on camshaft (122).
e.
Diameter of Number 2 journal on camshaft
must be 1.9845 to 1.9875 in. (50,406 to 50,482
mm).
f.
If Number 2 journal is less than 1.9845 in.
(50,406 mm), replace camshaft (122).
GO TO NEXT PAGE
2-179
