TM 5-3895-373-34
2.17
DIESEL ENGINE REPAIR.
C.
INSPECT - Continued.
4.
INSPECT THRUST WASHER BEARINGS AND
MAIN SLEEVE BEARINGS FOR WEAR.
a.
Use an outside micrometer (Item 15, Appendix
D) to measure thickness of Surface K on
thrust washer bearings (137).
b.
Thrust washer bearing thickness on Surface K
must be 0.089 to 0.091 in. (2,26 to 2,31 mm).
c.
If thrust washer bearing thickness is less than
0.089 in. (2,26 mm), replace thrust washer
bearings.
d.
Use an outside micrometer (Item 15, Appendix
D) to measure thickness of Surface L on main
sleeve bearings (138).
e.
Main sleeve bearing thickness on Surface L
must be 0.0822 to 0.0825 in. (2,088 to 2,098
mm).
f.
If main sleeve bearing thickness is less than
0.0822 in. (2,088 mm), replace main sleeve
bearing.
5.
INSPECT
CONNECTING
ROD
ASSEMBLY
SLEEVE BEARINGS, PISTONS, GUDGEON PIN,
AND CONNECTING ROD ASSEMBLIES FOR
WEAR.
a.
Use an outside micrometer (Item 15, Appendix
D) to measure the thickness of Surface M on
connecting rod assembly sleeve bearings
(100).
b.
Sleeve bearing thickness on Surface M must
be 0.0723 to 0.0726 in. (1,836 to 1,844 mm).
c.
If sleeve bearing thickness is less than 0.0723
in. (1,836 mm), replace sleeve bearings.
GO TO NEXT PAGE
2-176
