TM 5-3895-373-34
C.
INSPECT - Continued.
g.
Use an inside caliper to measure width of
connecting
rod
journal
Surfaces
G
on
crankshaft assembly (136).
h.
Connecting rod journal width on Surfaces G
must be 1.5885 to 1.5915 in. (40,35 to 40,42
mm).
i.
If connecting rod journal width is greater than
1.5915 in. (40,42 mm), regrind or replace
crankshaft assembly (136).
j.
Use an inside caliper to measure width of
Number 2, Number 4, and Number 5 main
journal Surfaces H on crankshaft assembly
(136).
k.
Number 2, Number 4, and Number 5 main
journal width on Surfaces H must be 1.545 to
1.549 in. (39,24 to 39,34 mm).
I.
If main journal widths are greater than 1.549 in.
(39,34 mm) regrind or replace crankshaft
assembly (136).
m.
Use an inside caliper to measure width of
Number I main journal Surface I and Number 3
main journal Surface J on crankshaft assembly
(136).
n.
Number 1 main journal width on Surface I must
be 1.453 to 1.473 in. (36,90 to 37,41 mm).
o.
Number 3 main journal width on Surface J
must be 1.738 to 1.741 in. (44,15 to 44,22
mm).
p.
If Number 1 main journal width exceeds 1.473
in. (37,41 mm), regrind or replace crankshaft
assembly (136).
q.
If Number 3 main journal width exceeds 1.741
in. (44,22 mm), regrind or replace crankshaft
assembly (136).
GO TO NEXT PAGE
2-175
