TM 5-3895-373-34
C.
INSPECT - Continued.
8.
INSPECT
BALANCER
UNIT
SLEEVE
BUSHINGS AND NEEDLE BEARINGS FOR
WEAR.
a.
Use a slide caliper to measure inside
diameters of Surfaces U in sleeve bushings
(144) in balancer unit frame end (91) and
frame (94).
b.
Inside diameter of sleeve bushings (144) in
balancer unit frame end (91) and frame
(94) must be 1.501 to 1.503 in. (38,133 to
38,174 mm).
c.
If sleeve bushing inside diameters are
greater than 1.503 in. (38,174 mm), replace
sleeve bushings. Refer to paragraph D.
d.
Turn needle bearings (145 and 146) by
hand. Feel for any roughness or excessive
play.
e.
If needle bearings turn rough, or show signs
of excessive play when turned, replace
needle bearings. Refer to paragraph D.
GO TO NEXT PAGE
2-181
