TM 5-3895-373-34
D.
INSTALL - Continued.
j
Install lockwashers (12) onto hex head cap
screws (11).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
k.
Apply thread locking compound to threads of hex
head cap screws (11).
l.
Install hex head cap screws (11) through guide
shaft support assembly (13) and into the front
wall of the extension screed.
m.
Tighten bottom three hex head cap screws (11)
to 180 lb-ft (244 N.m) using socket wrench
adapter (Item 6, Appendix D). Repeat tightening
with top three hex head cap screws.
n.
Install lubrication fittings (24) into inner and outer
lift jack assemblies (25 and 26).
o.
Lubricate
screed
extension
shaft
support
bushings on guide shaft support assembly (13)
per LO 5-3895373-12.
p.
Fully extend screed per TM 5-3895-373-10 and
tighten inside hex head cap screws (22) to 515
lb-ft (698 N.m) using the socket wrench set.
q.
Full retract screed per TM 5-3895-373-10 and
tighten outside hex head cap screws (22) to 515
lb-ft (698 N.m) using the socket wrench set.
r.
Run extension screed full in and out per TM 5-
3895373-10 and check for any binding during
travel. If binding is found, loosen hex head cap
screws (22) and repeat steps n and o until no
binding is found.
s.
Disconnect overhead hoist (21) from sling straps
(19) and remove the sling straps from the
paving machine.
t.
Install lockwasher (15) and flat washer (16) onto
hex head cap screw (14).
u.
Apply thread locking compound to threads of hex
head cap screw (14).
v.
Secure hydraulic hose (18) with clamp (17) to
extension screed frame using hex head cap
screw (14).
GO TO NEXT PAGE
2-1055
