TM 5-3895-373-34
A.
REMOVE - Continued.
3.
REMOVE GUIDE SHAFTS, PLAIN SEALS, AND
SLEEVE
BUSHINGS
FROM
GUIDE
SHAFT
SUPPORT ASSEMBLY.
a.
With the help of a second person holding guide
shaft support assembly, slide guide shafts (20)
from the guide shaft support of the guide shaft
support assembly.
b.
Remove plain seals (29) from both sides of
guide shaft support assembly. Discard plain
seals.
c.
While still installed, inspect sleeve bushing (30)
inner surface and outer edges for gouges,
cracks, pitting, or other damage that will affect
the full extension of the extension screeds. If
damage is found that requires the replacement
of the sleeve bushings, use the mechanical
puller kit and remove the sleeve bushings from
guide shaft support (31). Discard sleeve
bushings.
d.
Remove lubrication fittings (32) from guide shaft
support (31).
B.
CLEAN.
1.
CLEAN GUIDE SHAFTS, GUIDE BARS, AND
GUIDE SHAFT SUPPORT.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93, 3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a. Use a cleaning cloth and cleaning solvent
and clean surface of guide shafts.
b. Dry with a clean, cleaning cloth.
GO TO NEXT PAGE
2-1051
