TM 5-3895-373-34
D.
REPLACE - Continued.
NOTE
Ensure shims, plate spacers, and spacers are
placed on new screed plates in same stud
location and position as on old plates.
Transfer shims, plate spacers, and spacers
one stud at a time to avoid error. Ensure
spacers transferred from trailing edge of old
screed plates are installed bevel side down
on trailing edge of new screed plates.
c.
Remove self-locking nuts (4) and flat
washers (5). Discard self-locking nuts.
d.
Transfer all spacers, shims, and plate
spacers
from
studs
of
old
plate
to
corresponding studs of new plate.
e.
Substitute new shims, plate spacers, and
spacers of same dimensions in place of
visually defective parts. Refer to diagram
for factory location of spacers (23 through
26) by size.
f.
If replacing a damaged shim or plate
spacer, measure damaged shim or plate
spacer with an outside micrometer and
replace with one of a comparable size.
g.
Move new screed plate and installed shims,
plate spacers, and spacers into mounting
position under screed frame. Ensure
spacers stay in position while moving
screed plate.
3.
ASSEMBLE SCREED PLATE TO SCREED.
a.
Align screed plate studs with mounting
holes on screed base.
GO TO NEXT PAGE
2-1031
