TM 5-3895-373-34
A.
DISASSEMBLE.
1.
REMOVE RETAINING RING FROM CYLINDER
HEAD.
a.
Insert spanner wrench into holes on cylinder
head (1).
b.
Hold screed extension cylinder and rotate
cylinder head (1) in direction of least
resistance until beveled edge of retaining
ring (2) appears in milled opening.
c.
Insert flat-blade screwdriver under beveled
edge of retaining ring (2).
d.
Rotate
cylinder
head
(1)
in
opposite
direction of step b until retaining ring (2)
emerges through milled opening.
e.
Continue to rotate cylinder head (1) and pull
retaining ring (2) from milled opening with
pliers.
2.
REMOVE PISTON ROD, CYLINDER HEAD,
AND PISTON FROM CYLINDER TUBE.
a.
Manually extend piston rod (3) to its full
length.
b.
Tap side of cylinder tube (4) with plastic
hammer to jar cylinder head (1) and piston
(5) loose from cylinder tube.
c.
Pull piston rod (3), cylinder head (1), and
piston (5) as an assembly from cylinder
tube (4).
GO TO NEXT PAGE
2-1035
