TM 5-3895-373-34
D.
REPLACE - Continued.
g.
If mounting main screed plate (12), place
flat washers (5) and self-locking nuts (4)
over studs (13 through 16). Refer to chart
below for tools required and installation
comments. Tighten self-locking nuts to 37
lb-ft (50 N•m).
h.
If mounting inner and outer extension
screed plates (17 and 18), place flat
washers and self-locking nuts onto studs
(19 through 22). Refer to chart below for
tools required and installation comments.
Tighten self-locking nuts to 37 Ib-ft (50
N•m).
i.
Remove C-clamps and spacer wedges from
between screed halves.
Stud
Tools
Removal Comments
13
3/4 in. socket, 1/2 in. drive ratchet, 10 in. extension
Reach into trailing edge of main screed.
14
3/4 in. socket, 1/2 in. drive ratchet, 6 in. extension
Place self-locking nuts on studs.
15
3/4 in. socket, 1/2 in. drive ratchet, 6 in. extension
Reach through trailing edge of main screed.
16
3/4 in. socket, 1/2 in. drive ratchet
Reach through trailing edge of main screed.
19
3/4 in. socket, 1/2 in. drive ratchet, 10 in. extension
Access directly. 10 inch extension prevents step interference.
20
3/4 in. socket, 1/2 in. drive ratchet, universal adapter,
Use universal adapter to bypass interference from walkway
10 in. extension
support.
21
3/4 in. socket, 1/2 in. drive ratchet, 10 in. and 6 in.
Combine extensions. Gain access to nuts through top of
extensions
extension screeds.
22
3/4 in. socket, 1/2 in. drive ratchet, 6 in. extension,
Access directly
universal adapter, 10 in. extension
NOTE
FOLLOW-ON-TASKS:
Adjust and align main and extension screed plates per
TM 5-3895-373-20.
Install main screed cover plates, if removed, per TM 5-3895-373-20.
Install endgates per TM 5-3895-373-20.
END OF TASK
2-1033
