TM 5-3895-373-20
A.
REMOVE Continued.
d.
Reach in through engine access cover area in
hopper and remove rubber boot covering starter
B terminal. Remove hex nut (28) from starter B
terminal.
NOTE
When removing slave cable (29) and
positive battery cable (6), ensure lead
wire 331 is not removed from starter
B terminal.
e.
Remove slave cable (29) and positive battery
cable (6) from starter B terminal.
f.
Remove cap screw (30), lockwasher (31), and
clamp (32) from the flywheel housing. Discard
lockwasher.
NOTE
Tie wraps are located as needed.
g.
Cut tie wraps (33) and remove positive battery
cable from paving machine. Discard tie wraps.
GO TO NEXT PAGE
7-147