TM 5-3895-373-20 C. INSTALL - Continued. 12. INSTALL  GUIDE  SHAFT  INTO  OPERATOR CONTROL   CONSOLE,   AND   SECURE   ONTO CONSOLE SUPPORTS WITH CLAMP CAPS. a. Place  operator  control  console  (8)  on  deck of paving machine. b. With the help of two other persons, lift guide shaft   (27)   and   slide   shaft   into   operator control  console  (8),  ensuring  handle  (7)  is loosened   to   allow   shaft   to   pass   through. Center control console on shaft. c. Lock handle (7) so operator control console (8) will not move. WARNING The    operator    control    console    and guide  shaft  weigh  approximately  200 lbs    (90    kg).        To    avoid    personnel injury,  use  a  hoist  or  get  assistance when  lifting  the  control  console  and shaft. d. Lift assembled guide shaft (27) and operator  control  console  (8),  and  set  ends of  shaft  in  slots  on  console  support  (31). Ensure  shaft  is  centered  in  right  and  left console supports. e. Install flat  washers  (29)  onto  hex  head  cap screws (28). WARNING Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. f. Apply  thread  locking  compound  to  threads of hex head cap screws (28). g. Install  hex  head  cap  screws  (28),  washers (29),   and   clamp   caps   (30)   into   console support (31).  Tighten cap screws to 90 lb- ft (122 N•m). h. Check  and  adjust  operator  control  console (8) per step  B.2.j  through  m  in  paragraph 11.4. i. Slide operator control console (8) to left as far as it will go and lock handle (7). GO TO NEXT PAGE 7-51