TM 5-3895-373-207.6.REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASSEMBLY - Continued.C.INSTALL - Continued.11.INSTALL GAUGE PANEL LEFT AND RIGHTSEALS AND ACCESS DOORS AND COVERPLATE ONTO OPERATOR CONTROLCONSOLE.WARNINGAdhesive is TOXIC and extremelyflammable. Keep away from heat,sparks, and open flames. Use only inwell ventilated areas. Do not breathevapors or swallow and avoid contactwith eyes and skin. Failure to do somay result in injury or death topersonnel.If personnel become dizzy whileusing adhesive, immediately get freshair and medical attention. Ifpersonnel swallow adhesive, do notinduce vomiting. Get immediatemedical attention. If adhesivecontacts eyes, flush eyes with waterfor 15 minutes and get immediatemedical attention. If adhesivecontacts skin, wash thoroughly withsoap and water.a.Apply adhesive to cover plate (40) sealarea.b.Install cover plate seal (41) onto cover plate(40).c.Apply adhesive to gauge panel left accessdoor (32) and gauge panel right accessdoor (33) seal area.d.Install door seals (38 and 37) onto gaugepanel left access door (32) and gaugepanel right access door (33).e.Install cover plate (40) and secure withbutton head cap screws. (39). Tighten capscrews.NOTEFor repair and adjustment of doorlatches, refer to paragraph 11.2.f.Install gauge panel left access door (32)and gauge screws panel right access door(33), both in the open position, and securewith screws (36), flat washers (35), and hexnuts (34). Tighten hex nuts.g.Close gauge panel left and right accessdoors (32 and 33) per TM 5-3895-373-10.GO TO NEXT PAGE7-50
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
