TM 5-3895-373-20
6.2.
REPLACE RADIATOR AND RADIATOR SHROUD - Continued.
B.
INSTALL - Continued.
2.
INSTALL RADIATOR.
To avoid personal injury, use a hoist
or
get
assistance
when
lifting
components that weigh more than 50
lbs (23 kg). Ensure all chains, hooks,
slings, etc. are in good condition and
are of correct capacity. Ensure
hooks
are
positioned
correctly.
Always use a spreader bar when
necessary. The lifting hooks must
not be side loaded.
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
a.
Clean threads of hex head cap screws
(13,
8,
and
5)
with
thread
locking
compound solvent.
b.
With the help of another person, lower
radiator (4) through front top left access
door.
c.
Install flat washers (7 and 10) and
lockwashers (6 and 9) onto hex head cap
screws (5 and 8) and lockwashers (14)
and flat washers (15) onto hex head cap
screws (13).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
d.
Apply thread locking compound to threads
of hex head cap screws (5, 8, and 13).
e.
Install hex head cap screws (5). Do not
tighten at this time.
f.
Install radiator bracket (16), hex head cap
screws (8 and 13), flat washers (12), and
hex nuts (11). Do not tighten cap screws
or hex nuts at this time.
h.
Tighten hex head cap screws (20, 17, 8,
and 5) and hex nut (11) to 37 lb-ft (50
N•m).
g.
Move radiator and shroud as necessary to
position engine fan in center of shroud
opening.
GO TO NEXT PAGE
6-6
