TM 5-3895-373-20
3.3.
REPLACE ENGINE OIL FILTER/COOLER ASSEMBLY COMPONENTS - Continued.
B.
CLEAN.
1.
CLEAN CONNECTOR, STRAINER HEAD, AND
OIL FILTER/COOLER MANIFOLD.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flash point for
Type III cleaning solvent is 200(F (93,
30C). Failure to do so may result in
injury or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
CAUTION
Use caution when scraping gasket
sealing surfaces with putty knife.
Putty
knife
may
score
sealing
surfaces and debris may fall into
open ports. Failure to do so may
result in poor sealing and leaking
from strainer head.
a.
Use a putty knife, if necessary, to remove
any gasket material from sealing surfaces
of oil filter/cooler manifold and strainer
head. Do not score the sealing surface or
allow any gasket material to fall into open
ports.
b.
Use a clean lint free cloth and cleaning
solvent to clean all parts. Use a parts
cleaning
brush
to
remove
any
hard
deposits.
c.
Dry with a clean lint-free cloth.
GO TO NEXT PAGE
3-10
