2. INSTALL ENGINE OIL COOLER

3.4. REPLACE ENGINE OIL FILTER/COOLER ASSEMBLY LINES AND FITTINGS

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
527

TM 5-3895-373-20 3.3. REPLACE ENGINE OIL FILTER/COOLER ASSEMBLY COMPONENTS - Continued. C. INSTALL - Continued. 2. INSTALL ENGINE OIL COOLER. a. Install gasket (6) in mating seat of engine oil cooler (5). b. With gasket facing up, seat engine oil cooler (5) in strainer head (10). Make sure that the engine oil cooler ports are facing to the right and are square (90°) to the hydraulic reservoir. c. Install connectors (4) and tighten to 27.5 lb-ft (37 N.m). 3. INSTALL OIL FILTER ELEMENT. a. Fill oil filter element (1) with clean engine oil until full. Allow time for oil to soak into filter element. b. Lubricate rubber seal on top of filter element with clean engine oil. c. Hand rotate oil filter element (1) onto connector (4) until seated against engine oil cooler (5). d. Tighten oil filter element an additional ¾ turn using the oil filter removal tool. CAUTION If hoses are not installed correctly, flow of coolant will be obstructed. e. Slide hose clamps (3) onto coolant hoses (2). Install coolant hoses on oil cooler and tighten hose clamps. NOTE FOLLOW-ON-TASKS: Add engine crankcase oil per LO 5-3895-373-12. Fill coolant system per paragraph 2.23.3. Install right access cover per paragraph 2.22. END OF TASK 3-12

Privacy Statement
Press Release
Contact