TM 5-3895-373-20
3.2.
ADJUST INTAKE AND EXHAUST VALVES - Continued.
C.
INSTALL - Continued.
Use caution when scraping sealing
surfaces with putty knife. Putty knife
may
score
sealing
surfaces
and
debris may fall into open ports.
Failure to do so may result in poor
seal and component damage.
c.
Use a putty knife, if necessary, to remove any
gasket material from sealing surfaces. Do not
score the sealing surface or allow any gasket
material to fall into the cylinder head assembly.
d.
Dry mating surfaces with a clean, lint-free cloth.
2.
INSTALL THE VALVE COVER AND OIL
BREATHER HOSE.
a.
Place valve cover gasket (13) onto cylinder head
assembly (12).
b.
Place valve cover (8) onto cylinder head
assembly (12).
c.
Install flat washers (11), lockwashers (10), and
bolts (9).
Do not overtighten bolts. If bolts
are overtightened, damage may occur
to valve cover or bolts.
d.
Tighten bolts securely.
e.
Connect oil breather hose (7) onto valve cover
(8) and tighten hose clamp (6).
GO TO NEXT PAGE
3-6
