TM 5-3895-373-20
B.
INSTALL - Continued.
NOTE
Reconnection procedure for left hand
and right hand screed lift cylinders is
the same. Left hand screed lift
cylinder is shown in this procedure.
3.
RECONNECT SCREED LIFT CYLINDERS.
a.
Remove lock pins (12), flat washers (14), and
clevis pins (13) from lower screed lifting
brackets.
b.
Cut tie wraps securing screed lift cylinders.
Position cylinders for installation. Line up holes
in piston rod end and lower screed lifting
bracket. Install clevis pins (13), flat washers
(14), and lock pins (12).
c.
Start up paving machine and place screed lift
switch in down position per TM 5-3895-373-10.
d.
Remove lock pins (10) and clevis pins (11) from
upper screed lifting brackets.
e.
Have another person use crowbar to pry up on
cylinder tube of left hand screed lift cylinder.
Line up hole in cylinder tube with hole in upper
screed lifting bracket. Install clevis pins (11) and
lock pins (10).
f.
Repeat procedure in step e to reconnect right
hand screed lift cylinder.
g.
Shut off engine and remove key from ignition
switch per TM 5-3895-373-10.
GO TO NEXT PAGE
2-463
