TM 5-3895-373-20
15.17. REPLACE/REPAIR FEED LIMIT SWITCH PADDLE ASSEMBLY - Continued.
A.
REMOVE - Continued.
2.
REMOVE FEED LIMIT SWITCH PADDLE
CONTROL ARM.
a.
Loosen hex nut (6) and remove thumbscrew (7).
b.
Slide feed limit switch paddle (8) down and out
of limit switch actuator mount (9).
c.
Remove self-locking nuts (10), flat washers (11)
and hex head cap screws (12). Discard self-
locking nuts.
d.
Remove control arm rubber extension (13) from
feed limit switch paddle (8).
e.
Drive out spring pins (14) and remove actuator
mount (9) from endgate support arm (5).
Discard spring pins.
f.
Remove cotter pin (15) and flat washers (16).
Discard cotter pin.
g.
Remove straight headed pin (17) and spring
(18). Discard compression helical spring.
GO TO NEXT PAGE
15-118
