TM 5-3895-373-2015.16. REPLACE/REPAIR ENDGATE HAND LEVER ASB.INSTALL.1.ASSEMBLE ENDGATE HAND LEVERASSEMBLY.Cleaning solvent, P-D-680, is TOXICand flammable. Wear protectivegoggles and gloves. Use only in awell ventilated area. Avoid contactwith skin, eyes, and clothes, and donot breathe vapors. Keep away fromheat or flame. Never smoke whenusing solvent; the flashpoint forType III cleaning solvent is 200°F(93,3°C). Failure to do so may resultin injury or death to personnel.If personnel become dizzy whileusing cleaning solvent, immediatelyget fresh air and medical help. Ifsolvent contacts skin or clothes,flush with cold water. If solventcontacts eyes, flush eyes with waterand get immediate medical attention.a.Clean all components with cleaning cloth,cleaning solvent, and wire scratch brush. Wipeaway all residue.b.Screw pawl rod (23) into rod end (18).c.Install pawl (26), flat washer (25), and cotter pin(24) onto pawl rod (23).d.Position spring (22) into mounting hole of lever(10).e.Secure latch grip (17) to lever (10) with flatwashers (21), machine screw (19), and hex nut(20). Do not overtighten hex nut.NOTEDo not overtighten hex nut securinglatch grip onto lever. The latch gripmust be able to move freely wheninstalled on lever.f.Secure rod end (18) to latch grip (17) with flatwashers (16), machine screw (14), and hex nut(15). Do not overtighten hex nut.NOTEDo not overtighten hex nut securingrod end in latch grip. Rod end mustbe able to move freely within latchgrip.NOTEDo not overtighten bolt securingpawl to lever. Pawl must be able tomove freely when installed on lever.g.Secure pawl (26) to lever (10) with bolt (13) andhex nut (12). Do not overtighten bolt.GO TO NEXT PAGE15-112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
