TM 5-3895-373-2015.16. REPLACE/REPAIR ENDGATE HAND LEVER ASSEMBLY - Continued.NOTEThere are four endgate hand leverassemblies on the screed. Thisprocedure refers to replacement andrepair of one right hand endgatehand lever assembly. Procedure isidentical for the remaining threehand lever assemblies. Right handendgate is shown in this procedure.A.REMOVE.1.REMOVE ENDGATE HAND LEVERASSEMBLY.Cleaning solvent, P-D-680, is TOXICand flammable. Wear protectivegoggles and gloves. Use only in awell ventilated area. Avoid contactwith skin, eyes, and clothes, and donot breathe vapors. Keep away fromheat or flame. Never smoke whenusing solvent; the flashpoint forType m cleaning solvent is 200°F(93,3°C). Failure to do so may resultin injury or death to personnel.If personnel become dizzy whileusing cleaning solvent, immediatelyget fresh air and medical help. Ifsolvent contacts skin or clothes,flush with cold water. If solventcontacts eyes, flush eyes with waterand get immediate medical attention.a.Clean around all hardware at hand leverassembly (1) using cleaning cloth, cleaningsolvent, and wire scratch brush. Clean asrequired to allow removal of hardware.b.Unhook chain (2) from hand lever assembly (1).c.Remove hex head cap screws (3), lockwashers(4), and hand lever assembly (1) from endgatesupport arm (5). Discard lockwashers.GO TO NEXT PAGE15-110
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business