TM 5-3895-373-20
A.
REMOVE - Continued.
2.
DISASSEMBLE ENDGATE HAND LEVER
ASSEMBLY.
a.
Remove hex head cap screws (6) and ratchet
(7).
Use care when removing retaining
rings. Retaining rings are under
spring tension and can act as
projectiles when released and could
cause severe eye injury.
b.
Remove retaining ring (8) from pivot of
mounting bracket (9) using snap ring pliers.
Discard retaining ring.
c.
Remove lever (10) and flat washer (11).
d.
Remove hex nut (12) and bolt (13).
e.
Remove machine screw (14), hex nut (15), and
flat washers (16).
f.
Separate latch grip (17) from rod end (18).
g.
Remove machine screw (19), hex nut (20), and
flat washers (21). Remove latch grip (17).
h.
Remove and discard compression helical spring
(22) from lever (10).
i.
Unscrew rod end (18) from pawl rod (23).
j.
Remove cotter pin (24), flat washer (25), and
pawl (26) from pawl rod (23). Discard cotter pin.
GO TO NEXT PAGE
15-111
