TM 5-3895-373-20
15.2.
REPLACE SCREED CONTROL BOX- Continued.
C.
INSTALL - Continued.
e.
Install ring terminals (16) onto emergency stop
switch and secure with terminal screws (15).
f.
Apply electrical insulating compound to indicator
light terminals and insert electrical contacts (14)
onto indicator lights.
Electrical insulating varnish fumes
can be harmful if inhaled. Use only in
a
well
ventilated
area.
Avoid
prolonged exposure to fumes. If
personnel become dizzy or drowsy
during use, get immediate medical
attention.
g.
Install ring terminals (13) to switches and secure
with lockwashers (12) and terminal screws (11).
Refer to wiring diagram for either right or left
screed control panel. Apply electrical insulating
varnish to ring terminals, lockwashers, and
screws.
Adhesive is TOXIC and extremely
flammable. Keep away from heat,
sparks, and open flames. Use only in
well ventilated areas. Do not breathe
vapors or swallow and avoid contact
with eyes and skin. Failure to do so
may result in injury or death to
personnel.
If personnel become dizzy while
using adhesive, immediately get fresh
air
and
medical
attention.
If
personnel swallow adhesive, do not
induce vomiting. Get immediate
medical
attention.
If
adhesive
contacts eyes, flush eyes with water
for 15 minutes and get immediate
medical
attention.
If
adhesive
contacts skin, wash thoroughly with
soap and water.
h.
Apply adhesive to panel seal mounting surfaces
of screed control box (9).
i.
Install panel seal (10) to screed control box (9)
by fitting panel seal over components and
pressing onto adhesive.
j.
Install tie wraps as needed.
k.
Install screed control panel (8) and secure with
button head cap screws (7).
GO TO NEXT PAGE
15-18