TM 5-3895-373-20 15.2. REPLACE SCREED CONTROL BOX - Continued. C. INSTALL - Continued. 2. INSTALL        SCREED        CONTROL        PANEL COMPONENTS, PANEL SEAL, AND SCREED CONTROL PANEL. NOTE Left   and   right   hand   screed   control panel   layouts   are   reversed   (left-to- right)  from  one   another.      Left   hand screed control panel has a fuel pump switch, indicator light, and an additional  circuit  breaker  connection on buss bar. a. Install   switches   (17   through   27)   onto   screed control  panel  (8)  by  installing  hex  nut  (31)  onto switch.      Install   switch   through   rear   of   screed control    panel,    and    install    dust    and    moisture boots (30), lockwashers (29), and hex nuts (28). Refer to legend and illustration. b. Install    indicator    lights    (32    through    36)    onto screed   control   panel   (8)   by   installing   indicator light    through    front    of    screed    control    panel. Secure    indicator    light    with    o-rings    (38)    and lockwashers (37). Refer to legend and illustration. c. Assemble     emergency     stop     switch     (39)     by installing    contact    blocks    (48),    direct    voltage adapter   (47),   lampholder   (46),   and   lamp   (45) onto   operator   switch   (44).      Install   assembled switch  through  rear  of  screed  control  panel  (8) and   secure   with   adjustment   ring   (43),   bezel gasket (42), bezel (41), and pushbutton (40). d. Install  panel  lamp  unit  (49)  by  pressing  with  a finger into front of screed control panel (8). LEGEND 17.  Fuel pump switch (LH only) 29. Lockwasher 39.  Emergency stop switch 18.  Panel light switch 30. Dust and moisture boot 40.  Pushbutton 19.  Main screed blower switch 31. Hex nut 41.  Bezel 20.  Main screed burner control switch 32. Screed fuel pump indicator light 42.  Bezel gasket 21.  Feeder control switch (LH only) 43.  Adjustment ring 22.  Flow gate switch 33. Main screed burner on indicator 44.  Operator switch 23.  Auger/conveyor reverse control light 45.  Lamp switch 34. Main screed blower indicator light   46.  Lampholder 24.  Tow point movement switch 35. Extension screed burner on 47.  Direct voltage adapter 25.  Extension screed control switch indicator light 48.  Contact blocks 26.  Extension screed blower switch 36. Extension screed blower 49.  Panel lamp unit 27.  Extension screed burner control indicator light switch 37. Lockwashers 28.  Hex nut 38. O-rings GO TO NEXT PAGE 15-14