TM 5-3895-373-10 3.3.6 Air Cleaner Filter Element Replacement. a. Open right access door per paragraph 2.24.1. b. Loosen  clamp  (1)  between  air  cleaner  deflector (2) and air cleaner intake (3). c. Remove air cleaner intake (3). d. Remove    wing    nut    (4)    and    seal    washer    (5) holding the air cleaner filter element (6). e. Slide   air   cleaner   filter   element   (6)   out   of   air cleaner deflector (2) and discard. f. Remove baffle (7) from air cleaner intake (3). g. Remove vacuum diaphragm (8). Cleaning  solvent,  P-D-680,  is TOXIC and     flammable.          Wear     protective goggles and gloves. Use   only   in   a   well   ventilated   area. Avoid   contact   with   skin,   eyes,   and clothes,  and  do  not  breathe  vapors. Keep away from heat or flame.  Never smoke when using solvent; the flashpoint for Type III cleaning solvent is 200°F (93,3°C). Failure  to  do  so  may  result  in  injury or death to personnel. If    personnel    become    dizzy    while using  cleaning  solvent,  immediately get   fresh   air   and   medical   help.      If solvent    contacts    skin    or    clothes, flush   with   cold   water.      If   solvent contacts  eyes,  flush  eyes  with  water and get immediate medical attention. h. Clean the interior of the air cleaner as follows. (1) Use a cleaning cloth (Item 1, Appendix D) moistened  with  cleaning  solvent  (Item  8, Appendix  D)  and  clean  the  interior  of  air cleaner deflector (2). (2) Use  a  cleaning  cloth  (Item  I,  Appendix  D) and  detergent  to  clean  air  cleaner  intake (3), baffle (7), and vacuum diaphragm (8). (3) Rinse air cleaner intake (3), baffle (7), and vacuum diaphragm (8) in clean water and air dry. i. Install air cleaner filter element (Item 3, Appendix D) as follows. (I) Install    vacuum    diaphragm    (8)    onto    air cleaner  intake  (3).    Make  sure  it  is  fully seated onto intake. (2) Install  baffle  (7)  until  fully  seated  into  air cleaner intake (3). (3) Install new air  cleaner  filter  element  (6)  in air cleaner deflector (2). (4) Install  seal  washer  (5)  and  wing  nut  (4), securing    air    cleaner    filter    element    (6). Tighten finger tight. (5) Install   air   cleaner   intake   (3)   and   secure with clamp (1).  Tighten band. 3-24