TM 5-3895-373-10f.Support access door open by placing supportrod (7) in support rod socket (8).g.If required, toolbox (9) can be removed by liftingit straight up out of the paving machine mainframe.h.To secure access to toolbox, perform thefollowing steps.(1)Lift the access door to release the supportrod (7) from the support rod socket (8).(2)Place the support rod (7) on the stowagehook (10).(3)Using the edge of the access door (6),lower the access door.(4)Push in on one end of the latch (5) and liftthe other end, then turn 90°.(5)Lower access door (6).(6)Turn the latch (5) 90° and lower to lock.(7)Secure access door closed with padlock(4).3..2 AddingEngineOila. Park the paving machine on level ground. Shutoff the engine per paragraph 2.11. Waitapproximately 5 minutes to let the oil drain fromthe upper parts of the engine.b. Open front top left access door per paragraph2.24.1.WARNINGEngine surfaces may be extremelyhot. Use a thick waste cloth or likematerial as protection from burnswhen touching hot engine parts.Contact with hot engine parts canlead to serious burns tofingers andhands.c. Check engine oil level using engine dipstick asfollows.(1)Remove engine dipstick (1) and wipeclean with a shop cloth.(2)Replace engine dipstick into crankcaseand pull out again to read engine oil level.Engine oil level should be between theMIN and MAX marks on the dipstick.Replace dipstick into crankcase.d. If engine oil is below the MIN mark on thedipstick, add engine oil as follows.(1)Remove oil filler opening cap (2) locatedon top of the engine by turning 1/4 turncounterclockwise and pull straight up.3-19
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business