TM 5-3895-371-24 & P
Section VIII. REPAIR OF ASPHALT TANK AND HOSES
3-9. Asphalt Tank.
Removal.
a.
(1)
On the right side, remove fuel tank (para 2-27).
(2)
Remove eight nuts on top of spring mounting bolts securing tank to the frame (fig. 3-105).
(3)
Remove three bolts holding fuel lines to tank (fig. 3-106).
(4)
Remove three fender bolts at center of fender (fig. 3-107).
(5)
Remove one bolt at rear of right fender brace (fig. 3-109).
(6)
Remove four bolts from tank bracket to sub frame (fig. 4-11).
(7)
Lift off intake hoses and hand spray hose (fig. 4-9).
(8)
Remove eight bolts from walkway brackets and remove walkway (see para 4-3).
(9)
Remove two smoke stacks (para 2-28).
(10)
Remove quadrant (para 2-29).
(11)
Remove air inlet tube (4) from low pressure burners (para 2-39).
(12)
Remove low pressure burners (para 2-39).
(13)
Remove asphalt pump (para 3-7).
(14)
Remove intake valve lever (para 2-30).
nuts (14), and two nuts (15).
(16)
On the left side, remove four bolts, tank to sub-frame (fig. 4-11).
(17)
Remove step from rear fender (fig. 5-3).
(18)
Remove air line (3) from control box (fig. 4.5).
(19)
Remove brace bolt from fender to tank brace (fig. 5-3).
(20)
Remove three bolts at center of fender (fig. 3-107).
(21)
Remove three clamp bolts and nuts holding air hoses to tank (fig. 3-106).
(22)
Remove two air lines from supply tank (fig. 3-114).
(23)
Remove two bolts from air supply tank and remove air tank (fig. 3-114).
(24)
Remove lamp wiring harness (para 2-10, fig. 2-3).
(25)
Remove bell assembly (para 2-12).
3-88
