TM 5-3895-356-14&P
the Inner race was removed and replaced, install outer
race in the motor cover using an arbor press and plug of
proper size.
It is Important that the roller bearing (44) be replaced as
a set only. If either race was replaced, the entire bearing
must be replaced.
20. Inspect the motor cover (4) bronze face for signs of
cavitation, excessive wear, contamination or other
damage. See Fig 221. If circular wear patterns cannot
be felt with a fingernail and if there are no nicks,
scratches or other damage, one or two passes across
500 grit emery paper on a lap table, will put the bronze
face in like-new condition.
Figure 222.
Cover rework specifications
Figure 221.
Inspecting motor cover
If scratches or the wear pattern can be felt, pass across
500 grit emery cloth as described above until scratches
can no longer be felt Every effort must be made to
remove any scratches that cross the lands on either side
of the kidneys.
Degrease the cover in a commercial degreaser, such as
Figure 223.
trichloroethylene and blow dry with compressed air
Installing motor cover
Check the reworked cover against tolerances in Fig 222.
If the cover does not fall within tolerance limits, it must be
22. Fill pistons (55) with new transmission oil allowing
discarded.
a small excess to spill over the face of the block (40).
21 If outer race of roller bearing (44) was removed from
23 Place a new gasket (53) on housing and position
the cover (4) during disassembly, or If.
cover (4), utilizing reference marks In housing and cover
Install six hex bolts (45) and lock washers (37) and
torque bolts In an opposite pattern to 450 In lbs. See Fig
126
