TM 5-3895-356-14&P
RECORDING SETTINGS WITH HYDROSTATIC DRIVE
1. Enter distribution rate m
tion at the required speed. (On
rate to the corresponding engine
space at lower left of chart.
units provided with two-speed P.T
R.P.M. with unit stationary. (All
2. Enter
corresponding
O.
Or auxiliary transmissions,
other
settings
must
also
distributor speed in space at lower
space is provided for these
correspond ).
center of chart.
settings also.) Maintain distributor
7. Use a different chart for
3. Enter bar length in left
speed and set hydraulic control in
each distribution rate. In time all
column of chart.
accordance with instruction Enter
necessary
settings
will
be
4. Enter pump discharge rate
the data m the appropriate column
recorded.
in second column of chart.
of chart.
5. Make a dry run at indicated
6. Whenever a repeat of the
Additional charts available m
distributor speed, noting the truck
distribution rate is called for with a
the "Etnyre Shot Guide" Copies
R.P M., transmission, gear, and
previously-recorded bar length, it is
may be obtained by writing E D
rear axle setting that provides best
only necessary to reset the pump
Etnyre & Co., 200 Jefferson St,
opera-
discharge
Oregon, Illinois 61061.
2
Dist. Rate 0.3 GAL/YD Dist. Sp 300FPM
Figure 29
Bar
Pump
Truck
Tran.
P.T.O.
Rear
Aux.
Bar
Pump
Truck
Tran.
P.T.O.
Rear
Aux.
Eng.
Axle
Tran.
Eng.
Axle
Tran
Length
Discharge
RPM
Gear
Gear
Gear
Gear
Length
Discharge
RPM
Gear
Gear
Gear
Gear
Dist .Rate
Dist. Sp
Dist Rate
Dist. Sp
24
