ASSEMBLY OF SCREED EXTENSION - cont.
9. Install the capscrews which attach the Strike-
11. Use gauge tool to check accuracy of Gauge
* off Plate to the Adjusting Bolts. Tighten the
and Pointer read-out when strike-off plate is
screws.
raised.
10. Adjust Strike-off Plate flush with screed ex-
12. Install the Back Cover. Tighten the screws.
tension bottom, then adjust Gauge zero (0) even with
top of Pointer.
INSTALLATION OF SCREED EXTENSION
3. Set extension with bottom tight against and
1. Remove Screed Plate.
nearly flush with screed bottom. Make up ap-
proximate shim packs for top bolts.
2. Remove Plate from heat duct.
4 Install the four bolts in the lower positions.
* Draw up a loose tension. (finger tightness)
Page 64