TM 5-3895-385-23-1
0180
Table 1. Propel Controller Offline Fault Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. No power to propel controller.
1. Turn keyless engine switch to the
AUX position (TM 5-3895-385-
10), but do not start engine.
2. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
Volts Direct Current (VDC),
W1 J2 Pin 1 and W1 J2 Pin 2
proceed to next test.
(WP 0451, Vol 3, Figure 2).
2. If voltage reads below 22 VDC,
turn keyless engine switch to the
OFF position (TM 5-3895-385-
10), and proceed to next
malfunction.
3. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, proceed to next test.
W1 J2 Pin 1 and W1 J2 Pin 47
(WP 0451, Vol 3, Figure 2).
2. If voltage reads below 22 VDC,
turn keyless engine switch to
the OFF position (TM 5-3895-
385-10), and replace main
wiring harness (WP 0373, Vol
2).
4. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, proceed to next test.
W1 J2 Pin 1 and W1 J2 Pin 48
(WP 0451, Vol 3, Figure 2).
2. If voltage reads below 22 VDC,
turn keyless engine switch to
the OFF position (TM 5-3895-
385-10), and replace main
wiring harness (WP 0373, Vol
2).
5. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, proceed to next test.
W1 J2 Pin 1 and W1 J2 Pin 49
(WP 0451, Vol 3, Figure 2).
0180-2
