TM 5-3895-385-10
0015
BOLT-ON SCREED EXTENSION KIT INSTALLATION -- CONTINUED.
NOTE
Auger extensions and material retaining plate extensions are labeled L and R (WP 0009).
Pieces labeled L should be installed on the left side of the BMPM; pieces labeled R should be
installed on the right side of the BMPM.
The procedure for installation and removal of the auger extensions is the same whether being
performed on the left side or right side. Left side shown.
12. Remove bolt (Figure 5, Item 7), nut (Figure 5, Item 8), and auger shaft cap (Figure 5, Item 1) from auger
(Figure 5, Item 6).
WARNING
The 4-ft auger extension weighs 170 lb (77 kg). Four personnel are required to lift component.
Failure to comply may cause injury or death to personnel.
CAUTION
Do not drop item being lifted. Failure to comply may cause damage to equipment.
13. Install 4-ft auger extension (Figure 5, Item 5), bolt (Figure 5, Item 7), and nut (Figure 5, Item 8) onto auger
(Figure 5, Item 6) with assistance.
14. Remove bolt (Figure 5, Item 4) and nut (Figure 5, Item 9) from 4-ft auger extension (Figure 5, Item 5).
15. Remove bolt (Figure 5, Item 3) and nut (Figure 5, Item 10) from 2-ft auger extension L or R (Figure 5, Item 2).
WARNING
The 2-ft auger extension weighs 89 pounds (lb) (40 kilograms (kg)). Two personnel are required
to lift component. Failure to comply may cause injury or death to personnel.
CAUTION
Do not drop item being lifted. Failure to comply may cause damage to equipment.
16. Install 2-ft auger extension L or R (Figure 5, Item 2), bolt (Figure 5, Item 4), and nut (Figure 5, Item 9) onto
auger (Figure 5, Item 6) with assistance.
17. Install auger shaft cap (Figure 5, Item 1), bolt (Figure 5, Item 3), and nut (Figure 5, Item 10) onto 2-ft auger
extension L or R (Figure 5, Item 2).
0015-11