TM 5-3895-373-34
2.67
REPLACE MAIN SCREED FRAME- Continued.
A.
REMOVE - Continued.
10.
REMOVE BLOWER ASSEMBLY.
a.
Disconnect blower motor electrical connector
(80) from screed harness electrical connector
(81).
b.
Remove hex head cap screws (82), flat washers
(83), and blower mounting bracket (84).
NOTE
If removing left hand main screed
blower
motor,
there
will
be
no
hydraulic hoses attached to blower
mounting bracket.
c.
Remove blower mounting bracket (84), with
blower assembly (85).
d.
Pull hydraulic hoses (86 and 87) from main
screed frame, leaving tube (55) attached to hose
(86).
11.
PULL
SCREED
HARNESS
FROM
MAIN
SCREED
FRAME.
COIL
AND
SECURE
SCREED HARNESS WITH TIE WRAPS.
12.
REMOVE SIDE PLATE.
a.
Remove hex head cap screws (88), lockwashers
(89),
and
flat
washers
(90).
Discard
lockwashers.
b.
Remove side plate (91).
GO TO NEXT PAGE
2-938
