TM 5-3895-373-34
A.
REMOVE Continued.
7.
REMOVE HYDRAULIC HOSES, TUBES, AND
FITTINGS FROM RIGHT HAND MAIN SCREED
FRAME.
a.
Place machinery wiping towels beneath hydraulic
hoses and fittings.
WARNING
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
CAUTION
Thoroughly clean hydraulic hoses
and fittings before disconnecting.
Always plug or cap off disconnected
fittings
to
prevent
intrusion
of
contaminants. Failure to properly
clean and cap off connectors may
result
in
hydraulic
system
contamination
and
equipment
damage.
b.
Tag and disconnect main screed vibration hoses
(46 and 47) from straight adapters (48 and 49).
Plug hoses and cap adapters with protective
caps.
c.
Tag and disconnect screed extension cylinder
hoses (50 and 51) from straight adapters (52
and 53). Plug hoses and cap adapters with
protective caps.
d.
Tag and disconnect left hand extension screed
vibration hose (54) from vibration motor tube
(55). Plug hose and cap tube with protective
caps.
e.
Tag and disconnect vibration motor tubes (55
and 56) from straight adapters (48 and 49). Plug
tubes and cap adapters with protective caps.
Remove tube (56) from main screed frame.
f.
Tag and disconnect screed extension cylinder
tubes (57 and 58) from straight adapters (52 and
53). Plug tubes and cap adapters with protective
caps. Remove tubes from main screed frame.
g.
Remove nuts (59 through 62) and straight
adapters (52 and 53) and (48 and 49) from main
screed frame.
h.
From inside of left hand main screed frame, pull
extension screed vibration hoses (54 and 63)
through openings in between main screed
frames until they are completely inside left hand
main screed frame.
GO TO NEXT PAGE
2-935
