TM 5-3895-373-34
A.
REMOVE - Continued.
5.
REMOVE SCREED ARM.
a.
Remove socket head cap screw (28) and
retainer (29).
b.
Use drive pin punch to drive out screed arm
pivot pin (30).
c.
Remove sleeve bushings (31) from main screed
pivot bores (32).
d.
Lift screed arm (33) from main screed frame.
6.
REMOVE HYDRAULIC HOSES, TUBES, AND
FITTINGS FROM LEFT HAND MAIN SCREED
FRAME.
a.
Place machinery wiping towels beneath hydraulic
hoses and fittings.
WARNING
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
CAUTION
Thoroughly clean hydraulic hoses
and fittings before disconnecting.
Always plug or cap off disconnected
fittings
to
prevent
intrusion
of
contaminants. Failure to properly
clean and cap off connectors may
result
in
hydraulic
system
contamination
and
equipment
damage.
b.
Tag and disconnect left hand screed extension
cylinder hoses (34 and 35) from straight
adapters (36 and 37). Plug hoses and cap
adapters with protective caps.
GO TO NEXT PAGE
2-933
