TM 5-3895-373-34
D. INSTALL - Continued.
Hydraulic fitting sealant can cause
eye damage or skin irritation. Wash
after skin contact. Wear safety
goggles/glasses when using. Avoid
contact with eyes or skin. If sealant
contacts eyes, flush eyes with water
and get immediate medical attention.
g.
Apply hydraulic fitting sealant to threads of
elbows (93). Install and tighten hoses (92) on
elbows.
h.
Start paving machine and raise screed 4 to 6
in. Above floor per TM 5-3895-373-10.
i.
Extend screed extension cylinder per TM 5-
3895-373-10. Jog screed extension cylinder
piston rod (96) slowly until piston rod is seated
in mating hole of extension screed (14).
j.
Lower screed and shut down paving machine
per TM 5-3895-373-10.
NOTE
Screed extension cylinder piston rod
hardware (2, 3, and 4) should be
installed to allow extension screed to
be repositioned during components
installation procedures.
k.
Install and tighten flat washer (4), lockwasher
(3), and hex nut (2). This hardware will be
removed and reinstalled during installation of
endgate.
GO TO NEXT PAGE
2-917
