TM 5-3895-373-34
D.
REPLACE Continued.
3.
INSTALL CONVEYOR ROLLER AND BEARING
UNITS AS AN ASSEMBLY.
a.
Place bearing units (4) onto conveyor roller (1).
b.
With the help of another person, position and
support bearing units and conveyor roller on
paving machine.
NOTE
Ensure bearing units are positioned with
lubrication fittings facing upward.
c.
Install flat washers (3) onto hex head cap screws
(2).
WARNING
Thread locking compound can cause eye
damage. Wear safety goggles/glasses when
using.
Avoid
contact
with
eyes.
If
compound contacts eyes, flush eyes with
water and get immediate medical attention.
d.
Apply thread locking compound to threads of hex
head cap screws (2).
e.
Secure bearing units (4) with hex head cap
screws (2).
f.
Tighten hex head cap screws (2) to 100 lb-ft
(135 N.m).
g.
Snug set screws (5) in place, but do not fully
tighten. Set screws will be tightened after
conveyor chain assembly has been installed and
aligned.
NOTE
FOLLOW-ON-TASKS: Install conveyor chain assembly per paragraph 2.61.
Lubricate bearing per LO 5-3895-373-12.
END OF TASK
2-891
