TM 5-3895-373-34
NOTE
This procedure is the same for both
the left and right side conveyor drag
plates. In this procedure only the left
side is shown.
A.
REMOVE.
1.
REMOVE FRONT CONVEYOR DRAG PLATE.
a.
Remove hex nut (1), flat washers (2), and
socket head cap screws (3).
b.
Raise cover flap (4).
c.
Pry front conveyor drag plate (5) loose from
main frame supports (6) with a crowbar.
Front conveyor drag plate weighs 80
lb (36 kg). To avoid personal injury,
ensure two persons are used for
removing drag plate. Failure to do so
may cause a serious injury.
d.
Slide front conveyor drag plate (5) to center
of the hopper.
e.
Pull front conveyor drag plate forward and
slide drag plate over front of paving
machine. Discard conveyor drag plate.
GO TO NEXT PAGE
2-853
