TM 5-3895-373-34
2.62
REPLACE CONVEYOR DRAG PLATES AND ENGINE INSULATION PAN - Continued.
A.
REMOVE - Continued.
2.
REMOVE CHAIN PLATE LID.
a.
Remove hex head cap screws (7) and flat
washers (8).
b.
Remove chain plate lid (9) from above
outboard side of rear conveyor drag plate
(10). Discard chain plate lid.
3.
REMOVE REAR CONVEYOR DRAG PLATE.
a.
Remove hex nuts (11), flat washers (12),
and socket head cap screws (13).
b.
Pry rear conveyor drag plate (10) loose
from main frame supports (6) with a
crowbar.
Rear conveyor drag plate weighs 75
lbs (34 kg). To avoid personal injury,
ensure two persons are used for
removing drag plate. Failure to do so
may cause a serious injury.
c.
Pull rear conveyor drag plate (10) forward
and slide drag plate over front of paving
machine. Discard conveyor drag plate.
GO TO NEXT PAGE
2-854
