TM 5-3895-373-34
2.61
REPLACE CONVEYOR CHAIN ASSEMBLY - Continued.
D.
REPLACE - Continued.
f.
If conveyor chain assembly is running okay
and not hitting the sides of the main frame,
remove set screws (48).
Thread locking compound solvent can cause
eye damage. Wear safety goggles/glasses
when using. Avoid contact with eyes. If
solvent contacts eyes, flush eyes with water
and get immediate medical attention.
g.
Clean threads of set screws (48) with
thread locking compound solvent and a
cleaning cloth. Dry set screws using a
clean, cleaning cloth.
Thread locking compound can cause eye
damage. Wear safety goggles/glasses when
using.
Avoid
contact
with
eyes.
If
compound contacts eyes, flush eyes with
water and get immediate medical attention.
h.
Apply thread locking compound to the
threads of the set screws. Install set
screws. Tighten set screws using a socket
wrench adapter and hex head driver socket
(Item 86, Appendix D) to 19 lb-ft (26 N•m).
i.
If the conveyor chain assembly is rubbing
against either side of the main frame,
proceed as follows:
NOTE
It may be necessary to move the conveyor
manually to access set screws (48).
(1)
Remove set screws (48).
(2)
Move conveyor chain assembly 1/4 in.
away from the main frame rail where
the chain assembly is hitting the main
frame.
(3)
Clean threads of set screws (48) with
thread locking compound solvent and
a cleaning cloth. Dry set screws using
a clean, cleaning cloth.
(4)
Apply thread locking compound to the
threads of the set screws (48). Install
set screws. Tighten set screws using
a socket wrench adapter and a hex
head driver socket (Item 86, Appendix
D) to 19 lb-ft (26 N•m).
(5)
Start engine and run conveyor in
forward
direction
using
manual
operation procedures per TM 5-3895-
373-10. Visually check alignment of
conveyor chain assembly and roller
shaft (36). Chain assembly should be
running either in center, or slightly off
center without hitting sides of main
frame. Stop conveyor and shut off
engine and remove key from ignition
switch per TM 5-3895-373-10.
GO TO NEXT PAGE
2-848
