TM 5-3895-373-34
2.54.
REPAIR HYDRAULIC HOSES, TUBES, AND FITTINGS - Continued
This task covers:
a.
Remove
b.
Clean
c.
Install
INITIAL SETUP
Tools:
References:
General mechanic’s automotive tool kit
TM 5-3895-373-10
(Item 106, Appendix D)
TM 5-3895-373-24P
Bench vise (Item 112, Appendix D)
Combination wrench (Item 116, Appendix D)
Equipment Condition:
Torque wrench (Item 132, Appendix D)
Center top left access door opened per TM 5-3895-373-10.
Center top right access door opened per TM 5-3895-373-10.
Right access door opened per TM 5-3895-373-10.
Materials/Parts:
Left access door opened per TM 5-3895-373-10.
Cleaning cloth (Item 6, Appendix B)
Hopper wings lowered per TM 5-3895-373-10.
Cleaning solvent (Item 31, Appendix B)
Electrical insulating compound (Item 10, Appendix B)
Electrical insulating varnish (Item 38, Appendix B)
Hydraulic fitting sealant (Item 26, Appendix B)
Machinery wiping towel (Item 37, Appendix B)
Pipe sealant (Item 27, Appendix B)
Protective caps (Item 3, Appendix B)
Tags (Item 34, Appendix B)
Thread locking compound (Item 13, Appendix B)
Thread locking compound solvent (Item 32, Appendix B)
Tie wraps (Item 36, Appendix B)
Lock screws
Lockwashers
Self-locking nuts
A.
REMOVE.
NOTE
This
procedure
covers
removal
and
installation
of
control
valves
and
flow
dividers located on the machine valve panel.
Before removing any component, refer to
general removal instructions in paragraph A.
1. This paragraph provides a listing of those
components that need to be removed to
provide access to a specific control valve or
flow divider. Perform only those procedures
listed to remove the item being replaced.
GO TO NEXT PAGE
2-735
