TM 5-3895-373-34
2.43
REPLACE/REPAIR AUXILIARY VIBRATION PUMP - Continued
B.
DISASSEMBLE - Continued.
Drive and idler gear teeth are highly
polished. Avoid contact with bare
fingers. Skin oils can erode polished
surfaces. Wear clean cotton or
polyester
gloves
when
handling
gears.
q.
Remove bearing units (29).
r.
Place bearing units (29), drive gear (30), and
idler gear (31) in separate plastic bags to protect
against contamination.
C.
CLEAN.
1.
CLEAN ALL METAL PARTS WITH CLEANING
SOLVENT.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,
3°C). Failure to do so may result in
injury or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Rinse all parts with cleaning solvent. Do not
clean off matchmarks on pump housing, covers,
drive gear, or idler gear.
GO TO NEXT PAGE
2-590
